Gunwale Rubber Gunnel Edging PVC

This type of gunwale rubber usually fits over an edge where two surfaces meet together. The ribbed section in the middle of the gunwale rubber is used to grip the edges and often does not need to be fixed into place using other means such as screws or adhesives.

All Gunwale is supplied as one contiuous piece.

Gunwale End and Corner Caps are also available.

FURTHER INFORMATION:

Our PVC Pontoon Fender and Gunwale Products require preparation before installing onto the desired project.

Product Installation:

The product can be installed by direct fixing with a screw or by the applicaton of a Marine Grade Adhesive.

To assist with installation, the product can be heated to 60 Degrees Celsius in an air circulation oven for a MINIMUM of 60 minutes and a MAXIMUM of 75 minutes.

NOTE 1: When direct fixing a Marine Grade Stainless Steel product must be used

NOTE 2: Heatproof gloves must be worn when handlign the heated product

Product Storage:

The product should be stored out of direct sunlight and proteced from dirt, dust etc.

Maintenance:

The product can be cleaned with a Marine Wash/Wax or in case of stains a mild abrasive cleaner such as JIF can be used.

We do not recommended cleaning with thinners, Petrol or Solvents.